I put together a deltor for the first time yesterday, and could not get it to square up. It's off by 1/8 to 1/4 inch, so the bottom of the door does not clear on the side opposite the hinge.i trird adjusting the two hinge clamps, but I think it's mor that the sides/back are out of whack. I can nudge it a bit and get the door to close, but it just seems flimsy. Is this normal? Any advice on getting it square? Thx
I had a few of these over the years and tightening the bottom part (where the metal frame meets the bottom plate) always sorted this issue for me. the screws are on the top of the detolf. Should be able to play with it as you stand it. Hope it helps